Safely securing a Kong to a crate

This is wonderful for introducing a dog to the wonders of his nice safe den, the crate!

Materials

• kong
• short eye bolt
• nut (comes with eye bolt)
• washer
• one and a half inches of double sided scotch tape
• carabiner
• socket wrench long enough to fit into kong

step 1. Put eye bolt through the small hole in the kong.

step 2. Place double sided tape over end of wrench

Step 3 Put nut on top of tape and push the nut and tape into the socket.

Step 4 Place washer over the end of the socket wrench pressing firmly on the tape sticking out of either side of wrench.

Step 5 Place middle finger through eye bolt and pick up kong with big hole facing down.

Step 6 Put socket wrench through the hole in kong. It helps to find the bolt by aiming for your finger through the eyebolt on the outside of the kong and gently feel for the bolt.

Step 7 Tighten the nut until finger tight. Don’t tighten too much!

Step 8 Attach carabiner to the eye hook.

Step 9 Stuff the kong with peanut butter, wet food, kibble, cheese, or other goodies. You may even freeze to make it last longer.

Step 10 Attach the kong to the back inside of the crate near the bottom so the kong is laying on its side. In order for your dog to have the kong he must be inside the crate. Start with the door open the entire time. After many days you may close the door for longer and longer periods while you dog is enjoying his kong.

How to make a One Match Fire

Fire is an important thing to have in a survival situation.  It allows you to stay warm, boosts morale, cook food, and purify water.  It is not as easy to make as you might think.  In a survival situation, or even when backpacking in the woods, one match is all it should take.

Here, we learn how to make a one match fire from our favorite outdoor guru, Rob Speiden.

First, you must gather kindling and tinder.  

Tinder should be light and fluffy.  This is what the match will light on fire.  People who get good at making fire are able to get tinder to alight in flame with a single spark.  This takes lots of practice, but can be done.  We shall be prepared, so no firebowes mate.

Bark that peels like paper from a tree such as cedar or birch, cotton dipped in Vasoline, char cloth, and lint from the dryer work well.  Unfortunately,  leaves do not work very well because they burn at such a low temperature it takes an enormous amount to light the kindling.  Gather far more tinder than you think you need.

Kindling are dry branches and twigs as big around as your thumb or smaller.  Only gather these from the dead lower branches of trees, not from the ground or they are likely to be wet.

If it snaps it is dry if it is green or wet it will bend.

Gather several armloads.  Then go back and gather more.  No one ever gets enough of this stuff.  Break the kindling into 6 inch lengths.

Find two forked sticks and break them off about 6 inches from the fork.  Shove these guys in the ground about a foot away from one another.  Now, break a twig off of a green branch and lay it across the two forks.  You want the branch to be green as you want it to resist burning for a long time. It will look like you are about to rotisserie a chipmunk.  (I heard they are quite tasty.)  Don’t jump the gun folks!  You are going to need this little frame to build your fire on, so put that rodent away.

Start building a little a frame house with the six inch lengths of kindling.  Make sure you have provided for airflow and enough room in the structure for your hand.  Pile it on. Remember, there’s not really any such thing as too much kindling.

The most important part of fire making:  Sit back and watch all of your hard work BURN!